☰
×
Login Register an account
Top Submissions Explore Upgoat Search Random Subverse Random Post Colorize! Site Rules Donate
6

Need a new cordless battery.

submitted by deleted to AskGoats 3.8 yearsSep 3, 2021 10:57:17 ago (+6/-0)     (AskGoats)

deleted


11 comments block

sort by: hot new top old low

[ - ] ModernGuilt 1 point 3.8 yearsSep 3, 2021 15:41:29 ago (+1/-0)

Fake or stolen. Either way, there's enough battery combo deals to accomplish this legitly

[ - ] GlowNiggerDick 2 points 3.8 yearsSep 3, 2021 12:31:37 ago (+2/-0)

More likely stolen.

[ - ] SparklingWiggle 3 points 3.8 yearsSep 3, 2021 11:04:23 ago (+3/-0)

I have had batteries rebuilt, but not DeWalt and been happy with them. I've not heard of counterfeit but I guess it happens. You might look up to see if their is a warranty service location near you and see if they have any deals.

[ - ] Rotteuxx 6 points 3.8 yearsSep 3, 2021 11:14:03 ago (+6/-0)

Do it yourself, open them up & check what type of cells are in there. You can order the same type with better mah & assemble it yourself with a soldering iron.

[ - ] BeefJerky 4 points 3.8 yearsSep 3, 2021 11:34:30 ago (+4/-0)

if its lithium battery you can start a big fire , as shown in the online videos, but good recharge cells to refresh your packs have little wire tails preattached on ends for safety

watch laptop refresh vidz and see what im yapping about

[ - ] Rotteuxx 4 points 3.8 yearsSep 3, 2021 11:36:01 ago (+4/-0)

If you're doing it with a low wattage iron, it's bound to happen because you'll heat up the entire cell before the solder melts.

[ - ] account deleted by user [op] 3 points 3.8 yearsSep 3, 2021 11:20:26 ago (+3/-0)

account deleted by user

[ - ] Rotteuxx 5 points 3.8 yearsSep 3, 2021 11:34:51 ago (+5/-0)

Np, just make sure your iron can go high enough to not have to leave it on there too long. Quick solderings are key.

[ - ] mannerbund 2 points 3.8 yearsSep 3, 2021 13:13:13 ago (+2/-0)

That was a problem for me the first time around, good tip to leave for others!

[ - ] KCobain27 3 points 3.8 yearsSep 3, 2021 12:29:36 ago (+3/-0)

I think you can get cells with tabs already welded on, then solder the tabs.

[ - ] deleted 0 points 3.8 yearsSep 3, 2021 20:25:31 ago (+0/-0)

deleted